Introduction: L.E.D. Earrings

By facebook.com/madscienceatwork
About: Once was a chef, now i'm a pizza tosser.... and that was a long time ago. Then I travelled the world, spent a lot of time in Antarctica, worked on pirate ships, and now I am in Melbourne...

I've made these simple earrings for friends before. They will glow well over 12 hours and can be made for less then 10 dollers of parts.
visit http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=8918082660&rd=1&sspagename=STRK%3AMESE%3AIT&rd=1

Step 1:

Gather
-2 Led's of choice.
-2 earring fishooks (hobby lobby)
-2 3 volt 1025 batteries (5 bucks a pair at radioshack)
-solder and gun
-small clip of wire (clipped mine off of a resistor)

Step 2:

I coil the negative wire on the led to match up with battery

Step 3:

Cut and bend the small clip of wire so that it will fit across the battery.
Solder the wire on the opposide side (positve wire) to hold the batter in place.

Step 4: Finall Step

I bend the end of the positive wire around the little hole in the earring hook.

Step 5: Hope You Enjoy

Check out http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=8918082660&rd=1&sspagename=STRK%3AMESE%3AIT&rd=1
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=8917339078&rd=1&sspagename=STRK%3AMESE%3AIT&rd=1its a link to where I am auctioning them off.